Finite element modeling of a nominal tetrachiral lattice under quasi-static compression with preliminary insights into manufacturing-induced geometric deviations

Authors

  • Vito Topić Brečević
  • Emina Hadzalic Faculty of Civil Engineering, University of Rijeka
  • Veronika Drechslerová
  • Petr Koudelka
  • Daniel Kytýř
  • Zvonimir Tomičević

DOI:

https://doi.org/10.21014/actaimeko.v15i4.2475

Keywords:

tetrachiral lattice, quasi-static compression, finite element model, nominal geometry, aas-manufactured geometry

Abstract

This study presents the finite element modeling of an SLA-manufactured tetrachiral lattice subjected to quasi-static uniaxial compression. The constitutive law of the base material was calibrated using cyclic compression tests performed on bulk specimens, providing the elastic modulus, yield stress, and true-stress--plastic-strain relationship. A three-dimensional finite element model of the nominal lattice geometry was developed in Abaqus and solved using the explicit solution scheme. The numerical predictions showed good agreement with the experimental force–displacement response during the initial stage of compression. However, the numerical model progressively overestimated the load-carrying capacity as the deformation increased. Preliminary comparison of the nominal CAD geometry with X-ray computed tomography (XCT) data revealed manufacturing-induced geometric deviations, that may contribute to the discrepancies between the numerical and experimental responses. These findings highlight the need for a finite element framework that incorporates as-manufactured geometries and representative boundary conditions derived from full-field measurements obtained using Digital Volume Correlation (DVC).

Downloads

Published

2026-11-17

Issue

Section

Research Papers