Comparison of fracture energy of concrete under static and cyclic loading

Authors

  • Petr Miarka University of Brno, Czechia
  • Kamila Kozakova Institute of Physics of Materials, Czech Academy of Sciences
  • Lucie Malíková Institute of Physics of Materials, Czech Academy of Sciences
  • Vlastimil Bílek VŠB — Technical University of Ostrava, Faculty of Civil Engineering

DOI:

https://doi.org/10.21014/actaimeko.v15i4.2505

Keywords:

fracture energy, concrete, damage, cyclic load

Abstract

Fracture energy is the primary input for any cohesive analysis of concrete, yet it is almost always measured under monotonic static loading, while real structures are loaded repeatedly. This paper compares the fracture energy obtained from static three-point bending of notched concrete beams with the value derived from the envelope of low-cycle tests on nominally identical specimens of the same mix. Beams with relative notch depths a/W = 0.3 were tested on a servo-hydraulic machine, with the crack mouth opening displacement (CMOD) measured by a clip extensometer. The static work of fracture reached 258 J/m² up to a common CMOD of 0.42 mm, against 249 J/m² for the two low-cycle specimens, a difference of 3.4 %. The damage obtained from the unloading stiffness exceeded 0.9 by a CMOD of approximately 0.2 mm, while the irreversible CMOD grew linearly with CMOD at a slope of 0.88 to 0.92.

Downloads

Published

2026-11-17

Issue

Section

Research Papers